Studio-electronics Boomstar Uživatelský manuál stáhnout pdf (Strana 15)

Studio Electronics Boomstar Manual 11 Panels

5.2 Top Panel

5.2.1 SEM Controls

NOTCH

Sweepsthe12dBltersettingfromlow-passtohigh-pass.The

position enables

the

BANDPASS

ltermode,passingfrequencieswithinacertainrangeandrejecting,or

attenuating frequencies outside that range.

5.2.2 SE80 and 700 Controls

The

FREQ

knobsetsthehi-passlter(cuto)frequency:thegreaterthevalue,thefewerlow

frequencies pass through.

The

RESONANCE

knobsetsthelterresonance.Theresonance,or“Q”emphasizes,orboosts

thecutofrequencyregion,andmakesthepresenceofharmonicsmoreapparent.

5.2.3 Patch Points - Modular Synthesis Control—Anti-MIDI

5.2.3.1

Control Voltage Input: External sources for control would include Modular synthesizers, and step

sequencers;onevoltperoctaveisthevoltagespecication.

5.2.3.2

GateInput:ExternalGateInput;a+5voltagesourceisrequiredtoopenthevoltagecontrolledamplier—

thealternativetoMIDInoteonando.

5.2.3.3

VoltageControlledFilterFrequencyModulationInput:Useanexternalcontrolvoltagetomodulatethe

lterfrequency;modulationintheaudiorangeresultsinamorecomplexwaveform.

5.2.3.4

VoltageControlledAmplierAmplitudeModulation:Useacontrolvoltagetoexternallymodulate

Amplieramplitudeforleveladjustmentsandtremeloeects.

5.2.3.5

OscillatorOutput:Combinedpre-lteraudiooutputofoscillator1andoscillator.Toneispre-amplier

andthereforeconstant.SendthissignaltoyourDAWormixeranduseliberallyorsparingly.Thepurity,

clarity and transparency of all frequencies concerned are quite apparent and lovely.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Žádné komentáře

Studio-electronics Boomstar Uživatelský manuál Strana 15